Rick_oleson
Tinkerer Username: Rick_oleson
Post Number: 459 Registered: 07-2006
Rating: N/A Votes: 0 | Posted on Tuesday, December 18, 2007 - 04:39 am: | |
that's much smaller than i had been envisioning! i was thinking of something more like the plastic grips on some of the Contaflexes. For a source of ABS to carve, you could pick up an old dial telephone at a junk shop, their housings were good quality ABS. Or for a bit of poetic justice, an old P&S camera: the better ones would probably be polycarbonate, the cheap junkers more likely ABS or maybe even high impact styrene.... any of those materials should be workable. |