Rate this post by selecting a number. 1 is the worst and 5 is the best.

Author Message   Monopix Tinkerer Username: Monopix Post Number: 156 Registered: 11-2008 Rating: N/A Votes: 0 Posted on Thursday, October 21, 2010 - 05:15 am:    I would remove the lens plate and shutter/lens assembly and check/clean all the contacts on the Release Rod board. Then reassemble and make sure the release Rods are properly adjusted. If you still have problems after that, you need a meter to check what is actually happening. Instructions for removing the lens plate is in the manual.