| Author |
Message |
    
Okhansen
Tinkerer
Username: Okhansen
Post Number: 3
Registered: 11-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, September 22, 2011 - 09:59 am: | 
|
The meter needle on my black 500 G stays up even if I put on the lens cap or take out the battery. Only after pressing the shutter release several times, the needle moves a bit down, but not all the way.
Pointing the camera against the sunshine, the needle moves up when I remove the lens cap, but I am not shure it shows the right value.
Is it possible to solve this problem, and if so, what should be done?
Oistein |
Waynemel
Tinkerer
Username: Waynemel
Post Number: 90
Registered: 08-2009
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, September 22, 2011 - 10:36 am: |
|
I'm interested in this question as well, as I have a Konica C35 with a similar problem. The needle on my camera does not return to the zero position when the lens cap is on. It therefore underexposes by at least a stop. I have been trying to figure out how to adjust the needle position so it is properly zeroed, but I cannot see any obvious way of doing this. |
|
