Author |
Message |
John Kelly
Rating: N/A Votes: 0 (Vote!) | Posted on Thursday, July 22, 2004 - 08:51 am: |
|
Anyone got any ideas on replacing/resticking a loose and worn rubber grip on a focussing/aperture ring on a lens |
Will
Rating: N/A Votes: 0 (Vote!) | Posted on Thursday, July 22, 2004 - 04:39 pm: |
|
Hi John, I recently replaced a loose (stretched) rubber grip on a 28mm lens with suede leather. I used 3M contact cement. Worked well. I put the seam towards the bottom when the lens was focused at infinity. I also did a Vivitar 200mm many years ago that had a taper to the barrel. So I used small pie shaped wedges of leather for this. That worked great and has an added "cool" factor to it. It's held up for 25+ years! Will |
Jon Goodman
Rating: N/A Votes: 0 (Vote!) | Posted on Thursday, July 22, 2004 - 06:56 pm: |
|
Hi, John. I'd suggest using self-adhesive 1/16" 100% pure neoprene sponge foam. It is tough, resistant to environmental pollutants, UV and it is soft and pleasant to the touch. The black color will look good with your lens, even if it is silver. For $6, I can send you a kit containing enough to fix the lens and re-seal the camera to which it attaches. You can even have some clean fun re-sealing it! To see, please go to E-Bay and search using the "by seller" option. Enter my ID...Interslice...and there you go. Good luck, Jon |
Peter Stind Rosendahl
Rating: N/A Votes: 0 (Vote!) | Posted on Saturday, July 24, 2004 - 06:55 pm: |
|
I have the same problem with the rubber on a Yashica 50mm SLR lens - it has grown - how can I make it crimp again? I tried to boil it - with no effect - want the lens to stay original. On some cameras it will be possible to place a thin piece of rubber or neoprene foam under the original piece of rubber without making it noticeable! |
Michael Linn
Rating: N/A Votes: 0 (Vote!) | Posted on Sunday, July 25, 2004 - 06:36 pm: |
|
Remove the rubber and clean it with a toothbrush and warm soapy water. Clean the place where it was on the lens with alcohol. Cut the removed rubber with a pair of sharp scissors or an X-acto knife with a straightedge. Place the rubber back on the lens and note the overlap. Cut off the overlap with whatever tool you used to make the original cut, so that you have a tight fit and a good joint. Run a thin band of contact cement around the lens, except where you want the joint to be (bottom of lens at infinity position recommended) and put a little more glue in the joint area. Reapply the rubber. |