| Author |
Message |
    
Ken Doody
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, April 11, 2005 - 06:20 pm: | 
|
I have a new (to me ;) ) Fed-3. After running a roll through I have some overlapping frames. Could this be typical of ratchetting the wind lever for 2 short strokes rather than using only one stroke (I'm used to my Pentax MX), or is this the "Fed transport problem"? If the latter, is there a quick fix?
Thanks for any advice,
Ken |
rick
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, April 11, 2005 - 06:40 pm: |
|
i'm not familiar with a perticular "fed transport problem"; kievs are known to have some issues in that area, i haven't seen it in feds (though i don't have a lot of experience with them, i only have one). i'd try shooting a roll winding with single strokes and see if that helps it.
: ) = |
Dave P.
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, April 11, 2005 - 10:16 pm: |
|
Hello,
There is a screw inside the take up spool. Tighten that a about 1 1/2 turns. The spool is supposed to slip a little as the film winds on and increases diameter on the spool....... |
DAVE P
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, April 12, 2005 - 12:08 pm: |
|
Hello Again,
Also , take out the rewind shaft and polish it with very fine emory cloth and re lube it so it will spin easier........... |
