| Author |
Message |
    
Zippyone
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, July 14, 2005 - 02:05 pm: | 
|
Hi,
I am removing the top of my K-1000 but I cannot figure out how to remove the counter/wind lever.
Everything else is off.
Any suggestions? |
clive
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, July 14, 2005 - 06:04 pm: |
|
Hello Zippyone Greetings from Dublin.
(1) Remove counter cover 3 small screws around sides
(2) Remove screw in centre of film counter
(NOTE) This screw unscrews (CLOCKWISE)
(3) Remove counter disc
(4) If there is a centre ring nut (silver)
2 slots remove this.
If not contact me on email.
(5) If step 4 O.K. remove next disc.
(6) Remove 3 screws holding winder retaining
spring, turn spring app.1/3 turn
remove spring and then winder lever
And remove plastic dust washer.
Thats it
Any Problems Contact Me.
P.S. Whats the problem with the camera.
I may be able to advise before you get in
to deep.
Best Regards, Clive. |
Zippyone
Rating: N/A
Votes: 0 (Vote!) | | Posted on Friday, July 15, 2005 - 03:00 pm: |
|
Hi Clive,
I figured out the reverse screw.
The problem was with the release button housing, it was canted inward from an accident (dropped with cable release attached). I removed the top, straightened the relase housing, reset the chromed push pin which had fell in, and straightened the release plate which was bent.
I did note that there are (at least) two different styles of the K-1000. The top of the rewind base was plastic on one and metal on the other.
Thanks for your assistance.
I also have one with a bad wind gear (someone forced the wind lever and severely stripped the wind gear) but I know I need parts for that repair and I will have to wait for another to come in so I can repair it. |
Clive
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, July 16, 2005 - 04:26 am: |
|
Hello Zippyone
Greetings from Dublin (again)
Glad to hear you were successful.
Next problem.
I have these gears , If you send me the damaged
gear i cansend you a good one you will also need
the gear beside it as this one usualy is damaged
also.
I will need to check if the damaged gear and the
new are identical.
Contact me on my email address if you require
my help.
Best Regards Clive. |
