Author |
Message |
Pcb
Tinkerer Username: Pcb
Post Number: 1 Registered: 12-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Wednesday, December 06, 2006 - 10:48 am: |
|
Hello, I recently acquired a used Canon A-1 camera in good shape, except for a problem --- once the shutter is tripped and the advance lever turned, the camera needs to be turned off then on again to take another picture. To explain in more detail: I turn the camera on. I push the shutter release button down part way and the metering info appears in the viewfinder as it should (metering appears to be correct, agrees with my other A-1's). Push the button all the way and the shutter is released. Advance the film. This is the end of proper functioning. Now if I push the shutter release button down part way nothing appears in the viewfinder, no meter reading, nothing. Push the button all the way and the shutter does not release. Now if I turn the camera off and then on again, the camera will work for one shot, then go "dead" again. Has anyone else had this problem? And if so, what is the cause or repair needed? Thank you in advance for any assistance you can provide. |
Pcb
Tinkerer Username: Pcb
Post Number: 2 Registered: 12-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Monday, January 22, 2007 - 05:31 am: |
|
Additional info to previous post: I noticed in addition to turning the camera off then on, if I push the battery check button the camera will work properly for one photo, then go "dead" again. Turn camera off then on or push battery check button and camera works perfectly for one shot. I understand that pushing the battery check button resets the camera's brain. Does anyone know why the camera needs to be reset after each photo to work? What causes this problem? What can be done to fix this problem? Any assistance would be appreciated. Thank you. |
Glenn
Tinkerer Username: Glenn
Post Number: 123 Registered: 07-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Monday, January 22, 2007 - 08:24 pm: |
|
The battery check button has no reset function on the A1. I would guess that what is actually happening; is that when you operate the check button, as the battery voltage is diverted from the operating to the test circuit, this gives the same result as switching off/on with main switch. ie in both cases battery voltage is remove from part of the circuit. As to what is causing this and a remedy, I cannot give a quick answer/fix. It would appear that for some reason, the electronic timing/sequence is not completing the normal cycle. Hence the need to 'restart' the camera. I suggest you get hold of a copy of the proper A1 repair manual and work your way through the fault finding charts. The A1 has a number of insulating posts/strips that can become contaminated with dirt, if this happens short circuits/high resistance leaks may occur. |
Krp
Tinkerer Username: Krp
Post Number: 21 Registered: 07-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Monday, January 22, 2007 - 10:22 pm: |
|
Yes, I've seen that happen on the A-1. The contamination Glenn described is usually found in the battery check portion of the circuitry. The fix requires removing the top cover. The battery check has the post/insulator holding it atop the main circuit board. |
Pcb
Tinkerer Username: Pcb
Post Number: 3 Registered: 12-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Tuesday, January 23, 2007 - 05:30 am: |
|
Glenn and KRP, Thank you for the thoughts. I'll try running the tests you mentioned. Thanks again. |
|