|
| Author |
Message |
    
Hadoque
Tinkerer
Username: Hadoque
Post Number: 1
Registered: 10-2007
Rating: N/A
Votes: 0 (Vote!) | | Posted on Wednesday, October 17, 2007 - 05:36 am: | 
|
Hi
I have a nikon F3 on wich I need to replace the display block (the one with the flash-led and the viewfinder illuminator bulb). To do this I need to remove the top cover on the rewind side. I have a repair manual for the camera, but I don't quite get how to disassemble the rewind crank. If I get the crank out the way, the rest should be easy.
If you want to, I can upload the pages from the pages from the manual...
Thanks
/Johan |
Fiftyfifty
Tinkerer
Username: Fiftyfifty
Post Number: 18
Registered: 07-2006
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, October 18, 2007 - 12:11 am: |
|
Hello Johan
The rewind crank is removed by holding the forked section in the body,and then turning the rewind crank anti-clockwise. Below that you will have prise up the black plate,use a needle or a sharp blade,the plate is glued down and is normally marked when you remove it.You will have to make a small forked screw driver to remove one of the 3 screws below the plate, but this is only a small problem.
Hope this helps.
Doug |
Rick_oleson
Tinkerer
Username: Rick_oleson
Post Number: 407
Registered: 07-2006
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, October 18, 2007 - 03:22 am: |
|
Ahhhh, glue and plastic.... wonder how they ever made cameras without those.....
: ) = |
Hadoque
Tinkerer
Username: Hadoque
Post Number: 2
Registered: 10-2007
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, October 18, 2007 - 01:54 pm: |
|
ok, that was easy. Thanks a lot! |
|
|
