| Author |
Message |
    
Jon__cambs
Tinkerer
Username: Jon__cambs
Post Number: 1
Registered: 06-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, June 05, 2010 - 06:54 am: | 
|
I hope this is the right place to post this question.
I finally managed to lay my hands on my Dad's old projector and was looking forward to showing the youngsters our old family footage, but the belt was broken. I have just replaced the belt drive but unfortunately what appears to be a piece of card, probably a heat deflector, fell out before I noticed where it went. I cant seem to match it up to any likely positions.
Can anyone help with a description or photo of where it goes?
Thanks Jon |
Retthom
Tinkerer
Username: Retthom
Post Number: 1
Registered: 06-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, June 13, 2010 - 06:51 pm: |
|
I have a Kodak Brownie 8 model a-15 projector that i bought in the 50's and the focus wasn't working since it has been stored in my attic for about 25 yrs. I took it apart, but am looking for an assembly book for it,as i have a couple of pieces that i am not sure where they fit. |
Retthom
Tinkerer
Username: Retthom
Post Number: 2
Registered: 06-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Tuesday, June 15, 2010 - 10:50 am: |
|
I have a Kodak Brownie 8 model a-15 projector that i bought in the 50's and the focus wasn't working since it has been stored in my attic for about 25 yrs. I took it apart, but am looking for an assembly book for it,as i have a couple of pieces that i am not sure where they fit.email @ [email protected] |
Jon__cambs
Tinkerer
Username: Jon__cambs
Post Number: 2
Registered: 06-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, June 19, 2010 - 07:36 am: |
|
Hi Retthom, perhaps we can help each other out. Do you have the UK spec projector; if not then it may be very different to mine, but let me know what parts you are not sure of and I'll see if I can help by looking at mine as the only piece not in it's original place is this card like shield.
Photo's might help identify parts.
I did contact a company over here in the UK that sells a repair manual but it's only a few pages and I'm not sure how detailed it is. It costs £14.95 but I didn't want to spend this especially as they weren't sure if it contained the info I needed.
Regards Jon |
Lad_o_pairts
Tinkerer
Username: Lad_o_pairts
Post Number: 1
Registered: 09-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, September 06, 2010 - 11:03 am: |
|
Hello Jon and Retthom,
I'm currently repairing a Kodak Brownie 8mm a-15 projector, and stumbled upon your posts.
I don't know if your posts are still current, or not.
But if they are, I have some photos of the inside of the projector.
If you're still working on the projector, I was thinking we could maybe help one another here?
My email address is: [email protected]
Best regards,
Grant. |
