Author |
Message |
Fredtheoyster
Tinkerer Username: Fredtheoyster
Post Number: 10 Registered: 09-2010
Rating: N/A Votes: 0 (Vote!) | Posted on Thursday, March 17, 2011 - 03:59 am: |
|
Hello again Folks, Just taken delivery of a Leningrad spring-drive rangefinder camera, which was simply described as 'broken' I've never handled one before, let alone repaired one, so would appreciate any advice. As the camera is, it can't be wound up, but operates as a conventional knob wind; ie. the shutter can be tensioned and film wound by turning the advance knob. Is this a normal situation - and how does one open up the spring motor safely to service it? All comments gratefully appreciated. Cheers, Jim |
Scott
Tinkerer Username: Scott
Post Number: 131 Registered: 07-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Thursday, March 17, 2011 - 10:49 pm: |
|
I've given this same tip a few times, but here's a safety warning: Those spring-driven cameras have about a couple of feet of spring steel, like a clock spring, which (if wound up tight) can be dangerous. I learned how NOT to do it. Be very careful opening the mechanism holding the spring. Try to manipulate the pawl to release the tension BEFORE opening it. |
John_cribbin
Tinkerer Username: John_cribbin
Post Number: 15 Registered: 08-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Wednesday, March 23, 2011 - 11:25 pm: |
|
Ah, the Leningrad, probably my favorite Soviet rangefinder. Unfortunately, due to being on the other side of the world from my collection, I can't dig mine out at the moment. From memory, the knob should just tension the mechanism and then it operates as a motordrive from the shutter release. My guess is that for the knob to advance the mechanism, it's already fully wound and not releasing, or due to a previous problem was converted to a single shot camera with conventional wind on. If I find any fix tips when I get home (I did have some) I'll get back with them. John |
Fredtheoyster
Tinkerer Username: Fredtheoyster
Post Number: 12 Registered: 09-2010
Rating: N/A Votes: 0 (Vote!) | Posted on Thursday, March 24, 2011 - 10:19 am: |
|
Much appreciated! I'll certainly welcome any notes you may have. I can always get on with replacing the shutter curtains before tackling the spring, so no hurry. Cheers, Jim |
John_cribbin
Tinkerer Username: John_cribbin
Post Number: 16 Registered: 08-2006
Rating: N/A Votes: 0 (Vote!) | Posted on Thursday, March 31, 2011 - 10:01 am: |
|
Ok back home and got mine out. The wind knob should initially cock the shutter when it's unwound. Once wound the shutter release will operate until the spring is unwound again. The ratchet mechanism is definitely at the top of the camera, so I'm guessing you will need to get the top off to investigate further. I've located some notes for the camera I've aquired over the years, so if you pm me your e-mail address I'll send them to you. |
Fredtheoyster
Tinkerer Username: Fredtheoyster
Post Number: 13 Registered: 09-2010
Rating: N/A Votes: 0 (Vote!) | Posted on Friday, April 01, 2011 - 06:17 am: |
|
Thanks very much! Address PM'd. - Jim |