| Author |
Message |
    
Paul_c
Tinkerer
Username: Paul_c
Post Number: 9
Registered: 02-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, March 29, 2010 - 03:45 am: | 
|
Restoring my Aires III L I found one of the diaphragm blades has lost the stud.I found the stud inside but too fix the stud back on the blade is not easily with no guarantee it will hold.
So I am looking for a new blade.If somebody has one,ore a complete shutter, I will be interested.
It is a 5-blade diaphragm, the total length is 29 mm, the length between the 2 studs is 26 mm.
Thanks,
  |
David_nebenzahl
Tinkerer
Username: David_nebenzahl
Post Number: 237
Registered: 12-2009
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, March 29, 2010 - 09:29 am: |
|
I wonder if epoxy would hold the stud on? I've repaired diaphragm blades that have lost their studs before, but this looks a bit trickier. Might be worth a try? |
Finnegan
Tinkerer
Username: Finnegan
Post Number: 32
Registered: 09-2009
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, April 03, 2010 - 12:13 pm: |
|
Does this shutter have any letters like Seikosha SLV or Seikosha MX or ? Is it plain Seikosha? I ask because the pic. looks a lot like the Seikosha in the Yashica TLRs (which I have parts for). |
David_nebenzahl
Tinkerer
Username: David_nebenzahl
Post Number: 253
Registered: 12-2009
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, April 03, 2010 - 06:06 pm: |
|
It's a Seikosha-MXL (at least my Aires 35-IIIL is). |
Paul_c
Tinkerer
Username: Paul_c
Post Number: 10
Registered: 02-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, April 04, 2010 - 06:41 am: |
|
David is right,it's a MXL shutter. I used cyanoacrylaat to glue the stud on the blade.It's all functioning well but only time will tell.
Finnegan: I can't tell You wether the Yashica shutter is the same but thanks for your interest.
regards, |
David_nebenzahl
Tinkerer
Username: David_nebenzahl
Post Number: 255
Registered: 12-2009
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, April 04, 2010 - 01:26 pm: |
|
Looks as if either epoxy or cyanoacrylate should hold the pin. Luckily the missing pin is on the pivot end, not the operating end of the blade, so not much force on it. |
