| Author |
Message |
    
Jules
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, June 25, 2005 - 08:00 pm: | 
|
Hi folks,
I’m requesting a bit of help. I have several auxiliary rangefinders that fit in a hot/cold shoe. Here is a pic of two of them
http://www.pbase.com/lulalake/image/45297724
I use them on older cameras that don’t have rangefinders like a Franka Solida III and a few much earlier ones. None of them read the same. Yuk.
Does anyone have a clue as where to get these calibrated?
I much appreciate the help
Jules |
Glenn Middleton
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, June 25, 2005 - 08:16 pm: |
|
Normally this is a relatively simple DIY job.Are you saying that your rangefinders do not have any adjustment screws?Usually all you need is a tape measure and a screwdriver. |
Jules
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, June 25, 2005 - 08:26 pm: |
|
Thanks, I just found an adjusting screw on one but not on the other one.
Jules |
Glenn Middleton
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, June 26, 2005 - 05:25 am: |
|
Jules,
I do not have many separate rangefinders but all mine have clearly seen adjustment screws.Might be talking rubbish, but seem to recollect in dim and distant past my Father adjusting one of his via the dial 'pivot' screw?
I hope that one of the Experts on this forum can help you more than I can.
Glenn |
Jules
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, June 26, 2005 - 02:17 pm: |
|
Glenn,
That's exactly where the adjustment screw is!
You helped a bunch and thanks again.
Jules |
